Import 3D harnesses geometry

It is always easier to interface with the 3D geometry of the harnesses.
New in the EVO module that allows you to use the 3D geometry of an harness to acquire its dimensions.


Now the new 'Redraw on 3D' mode allows to redesign the harness directly starting from the Center-Line of the 3D design. Even highly complex cabling can be redesigned in 2D either on a 1: 1 scale or off-scale with extreme easily and very quickly.
Being able to use the 3D geometry of harnesses conceived as part of the mechanical design of a vehicle or a machinery makes it possible to construct the real prototypes of the harnesses while the mechanical construction takes place. This avoids the construction of the harnesses at the end of the mechanical construction, after the measurements of the wiring are acquired through the dimensional technical survey, creating delays in the start-up of the vehicle or machinery. The electrical construction goes hand in hand with the mechanical one.

Contact us for further information at number +39 011 614236 or with mail at techdept@cadable.it




Latest news ..

See summary of news

Import 3D harnesses geometry
CABLING is interfaced with WEETECH


Last Articles..

See summary of articles

Racing Team of 'Politecnico' University of Turin
EngNetwork - Engineering software Network

 
 
CAD.Able S.r.l. - P.iva 07300750010 copyright 2009-2011 CAD.Able S.r.l.